This
page is for those who want the instruction to fold a simple origami frog II.
This simple origami frog II starts from a 16x16 matrix base. There is no special folding technique involved with this model.
Before working on this model, you need to know what valley-fold and mountain-fold are. If you know these two folding techniques, then you will have no problem in making origami frog.
If you are ready, then let's get started.
If you find any bugs on this instruction, please send an email to .
You may use any kind of paper to fold this origami frog. Make sure the paper
that you use is a square(all sides are equal and all the angles
equal 90 degrees). The paper I am using here is 15cm x 15cm square one. It is a good size for those who are not experienced in paper folding. If you are become familiar with this model. Then you can try smaller size paper.
00A.
This is the front side of paper.
00B.
This is the back side of paper.
00C.
This is the crease pattern (CP) of this model.
You can refer to this CP if you have a problem in following the instructions.
.
